谁帮我翻译下这段文字，翻成英文，如果正确无误会再加分，重金急求！！！！！！
发布网友
共6个回答
热心网友
目前D类音频功率放大器具有成本低、效率高、音响效果好的特点，同时还存在着很多的缺点，如失真度大，不易调试等一些需要改进的地方。
The current class D audio power amplifier is characterized with low cost, high efficiency and good sound effects, as well as a lot of disadvantages, such as high distortion and difficult debugging/adjustment, which need to be improved.
本设计的原理是D类功放是放大元件处于开关状态时的一种放大模式。
The principle of this design is to make/keep the amplifying element of class D power amplifier in the amplification mode when switch is on.
无信号输入时放大器处于静止状态，不耗电。工作时，打开开关，接通电源，接入音频输入，产生音频信号，和运放产生的三角波信号同时通过比较器，通过比较产生PWM调制波信号，再通过死区保护进入LC低通滤波器，过滤成音频信号经过放大后输入扬声器，放出声音。
When there is no signal input,the amplifier is in the off state with no power consumption. When the power switch is turned on and the audio input is connected, the amplifier is in working state, the signals transmitted by audio input pass through the comparator simultaneously with the triangle wave signals generated by OPAMP, and by comparing the two, it generates PWM molated wave signal which, with the protection of the dead zone, enter the LC low-pass filter, filtrated into audio signals, and transmitted into speaker via amplifier to proce sound.
采用运放芯片OP07组成三角波产生电路，比较器采用LM393N。
The OPAMP chip OP07 is used to form a triangular wave for generating circuit, and the LM393N is used for comparator.
最后通过硬件电路进行系统的调试，实现了系统的整个功能。
Finally, the system is adjusted via hardware circuit to achieve the complete function of the system.
热心网友
The class D audio power amplifier has the characteristics of low cost, high efficiency, good sound effects, but there is still many drawbacks, such as high degree of distortion, not easy to debug and some other areas where improvement is desirable. The principle of this design is the class D power amplifier in which the amplification element is in a state of amplification switch mode. When there is no signal input, amplifier is in the cutoff state, and no power is consumed. To make it work, turn on the switch, plug in the power and access to audio input, the resulting audio signal and the triangular wave signal generated by operational amplifier circuit pass the comparator at the same time. By comparison, the PWM molated wave signal is generated, which then enters the LC low-pass filter through the dead zone protection, and filtered into the audio signal that is amplified for the input of the speaker, then sound is emitted. The operational amplifier chip OP07 composes triangular wave generating circuit, and comparator LM393N is used. Finally, by debugging the system through the hardware circuit, the full function of the system is achieved.
热心网友
The class D audio power amplifier with low cost, high efficiency, sound effect good characteristic, but also there are many shortcomings, such as distortion degree is big, not easy debugging and so on some need improvements the place. The principle of this design is class D power amplifier is one of the types of the amplifier is in a state of switch mode. When no signal input amplifier in the cutoff state, no electricity. Work, open the switch, plug, audio input, an audio signal, and put the triangular wave signal by the comparator at the same time, by comparing to proce PWM wave signal, again through the dead-zone protection into the LC low-pass filter, the filter input speakers into audio signal after amplification, emit sound. Using operational amplifier OP07 chip form a triangle wave generating circuit, comparator using LM393N. Finally through the hardware circuit system debugging, the whole function of the system.
请采纳，谢谢
热心网友
Theclass D audio poweramplifierhas the characteristics of low cost,high efficiency,good sound effects,there is alsoa lot of disadvantages,such asdistortion,not easy todebugand some otherareas in need of improvement.The principle of thedesign of theclass D power amplifieris theamplification elementin azoom modeswitchstate.No signal inputamplifierin the off state,no power consumption.When working,turn on the switch,switch on the power,accessaudio input,audiosignal,triangle wavesignalgenerated by thecomparatorand operational amplifierat the same time,through the comparison ofthePWM molated wave signal,and then enter the LClow-pass filterthrough thedead zone protection,filtered intothe audio signalis amplifiedinputspeaker,sound.Theoperational amplifierchip OP07triangular wave generating circuit,comparatorusing LM393N.Finally,debugging the systemthrough the hardware circuit,realizesthefunction.
热心网友
现在翻译器很多，有在线翻译的，你可以自己复制进去，然后选择你想要的语言就可以了
热心网友
下面的都是不懂装懂的
